![]() That Duet Wifi might be able to do it, but if you can find / buy the parts to put a stratasys controller back on the machine you'll end up with a much better overall system. ![]() What to I need to do to drive the motors? What hardware do I need? Is it even possible? The power distribution board reads: PWB 201389-0003 REV JÄate code on the display board reads: E0205 I'm also not even sure what the model is, it's old enough for the configuration disk to be on a floppy disk. I'm at a loss as to how to interface everything. Secondly they require double the pins to control them compared to a Pololu driver. I have been looking into how to run the printer with an Arduino and RAMPS board but have had zero luck as for one the motors are 3A continuous with a 6A peak. I have the power supply, driver board, motors etc. I came into possession of a Stratasys that had been decommissioned, Perfectly functioning except they took the brains and the printer head. The author is trying to accomplish something similar to to my own goals. Before I begin my spiel I'd like to preface by saying after hours of googling I found a wonderful forum with more information on one page than days and days of research have produced, only for it to be YEARS old, turns out it was this one.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |